Door Reversal; Instructions For Totally Built-In - Zanussi ZPL 7120 Instruction Booklet

Door reversal

Right hand door opening
Remove the upper and lower screws (1) and
pivots (2) with the safety washer (4) on the left
side (Fig. 2). Remove the door stop hinge (3-
Fig. 3).
Left hand door opening
Remove the upper right screw and pivot.
Straighten the safety washer (4) of the lower
right hinge. Remove the screw (5) and the pivot
(ó) (Fig. 3). For safety reasons bend the washer
located under the left hinge (Fig. 4), by using a
tool (for ex. a screw driver). Remove the right
door stop hinge (3-Fig. 3).
Fitting the handle
Holes for fitting the handle on the opposite side
are provided, with fixing screws already in
place.
I nstructions for totally built-in
appliances
Dimensions of the recess
Height 880 mm
Depth 550 mm
Width 560 mm
The appliance's door has been locked in
position for transport by means of pins on
both sides. According to the door opening
direction, remove relevant pins at the top and
at the bottom.
For safety reasons, minimum ventilation must be
as shown in Fig. 5.
Attention: keep ventilation openings clear of
obstruction.
1
2
D561
3
D562
6
4
5
D563
50 mm
D567
Fig. 2
Fig. 3
6
4
5
Fig. 4
Fig. 5
min.
2
cm 200
37