Maintenance; The Water Inlet Filter; The Drain Pump Filter - Kenmore 501-40002 Owner's Manual And Installation Instructions

M aintenance
Before cleaning the washer interior, unplug the electrical power cord to avoid
electrical shock hazards.

The water inlet filter

- error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is a good idea to clean it from time to time.

The drain pump filter

The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
CAUTION Drain, using the drain hose, before opening the pump filter to remove objects.
!
Allow the water to cool down before cleaning the drain pump, carrying out emergency
emptying or opening the door in an emergency.
1. Open the lower
cover cap by
using a coin. Drain
plug to pull out
the hose.
0 1 0
1
1. Turn off the
water tap.
3. Clean the filter
using a hard
bristle brush.
2. Unplug the drain plug
allowing the water to flow out. At
this time use a vessel to prevent
water flowing onto the floor. When
water does not flow any more, turn
the pump filter open to the left.
2
3
3. Remove any foreign objects from
,
the pump filter
After cleaning, turn the pump
filter
drain plug
place. Close the lower cover cap.
2. Unscrew the
water inlet
hose.
4. Tighten the
inlet hose.
.
clockwise and insert the
to the original
2
3
17