Makita BSS610 Instruction Manual page 10

ASSEMBLY
1
1. Shaft lock
2. Hex wrench
1
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex. bolt
1
1. Hex wrench
10
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
Removing or installing saw blade
006706
CAUTION:
• Be sure the blade is installed with teeth pointing up at the front of the
tool.
• Use only the Makita wrench to install or remove the blade.
To remove the blade, press the shaft lock so that the blade cannot revolve and
use the wrench to loosen the hex bolt clockwise. Then remove the hex bolt,
2
outer flange and blade.
To install the blade, follow the removal procedure in reverse. BE SURE TO
006707
TIGHTEN THE HEX BOLT COUNTERCLOCKWISE SECURELY.
When changing blade, make sure to also clean upper and lower blade guards
2
of accumulated sawdust. Such efforts do not, however, replace the need to
4
check lower guard operation before each use.
3
Hex wrench storage
006708
When not in use, store the hex wrench as shown in the figure to keep it from
being lost.