Zanussi Electrolux ZNB 3840 Instruction Book page 17

Do not forget to remove the plastic spacer (b) under the
hinge. (fig.2)
5. Take off the refrigerator door by pulling it slightly
downwards.
6. Take of the freezer door by pulling it slightly upwards.
7. Remove the plug on the upper side of the refrigerator
door and put it to the other side.
8. Remove the plug on the upper side of the freezer door
and put it to the other side.
9. Unscrew the top door hinge pin (d) of the refrigerator
then screw it back on the other side. (fig.1)
10. Remove the plugs (u) at the bottom of the appliance.
(fig. 3)
11. Remove the lower hinge (e) by removing its screws (s)
and mount it on the other side. (fig.3)
12. Unmount the lower hinge pin (f) and its washer (h) and
mount them into the other hole of the lower hinge.
(fig.3)
13. Replace the plugs (u) on the other side.
14. Remove the covering nails (3 pieces) (n, k) of the
double door holder on the left side and put them to the
other side. (fig.2)
15. Fit the pin of the double door hinge (m) into the left drill
of the freezer door. (fig.2)
16. Fit the freezer door to the lower door hinge pin (f).
(fig.3)
17. Fit the refrigerator door to the upper door hinge pin (d)
then slightly tilting both doors fit the pin of the double
door hinge (m) into the left drill of the refrigerator door.
18. Opening both doors fix the double door hinge onto the
left side using the screws (2 pieces) (c). Do not forget
to replace the plastic spacer (b) under the hinge. Be
careful that the door edges are parallel with the edge of
the mantle.
19. Put over the handles (r) on the other side and put the
plastic covering nails (p) supplied in the plastic bag of
this instruction book into the holes set free. (fig.4)
20. Put the appliance to its place, set it level, and apply
voltage to it.
In case you do not want to perform the procedures above,
call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for charge.
Important
After completion of the door reversing operation, check that
the door gasket adheres to the cabinet. If the ambient
temperature is cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by heating
the part involved with a normal hairdryer on a low setting.
fig. 2.
fig. 3.
fig. 4.
17