Table of Contents
Advertisement
top of compressor and evaporates due to its warmth.
Check and clean the outlet of melting water
coming during defrosting regularly - a label
inside the appliance warns you for this. If it is clogged
the melting water gathered can cause earlier failure as
it can go to the insulating of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe scraper has
to be stored in the outlet.
The most typical case of clogging up in the melting water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of the
refrigerator and freezes to it. If you remove the food right at
this moment the paper will tear and it can cause clogging up
in the outlet by getting into it.
So you are asked to be careful - because of the above -
when placing foods wrapped in paper into the appliance.
In case of increased demand e. g. during
heatwawes, the refrigerator temporarily happens to
operate constantly - during this the automatic defrosting
does not work.
Remaining small ice and frost stains on back plate of the
refrigerator after defrosting period is not abnormal.
Defrosting of the freezer is automatic in this model.
Important
A temperature rise of the frozen food packs during
defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from the
evaporator as this could damage the appliance beyond
repair.
To Change the Light Bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the cover
in the direction indicated by the arrow (2). So the bulb can
be replaced. (Bulb type: T 25 230-240 V, 25 W, E 14
thread)
After changing the bulb replace the cover, snap it in place
and apply voltage to the appliance.
11
Advertisement
Table of Contents
