Specification - Ryobi ECS12519 Owner's Operation Manual

DESCRIPTION
1. Spindle lock button
2. Hex-head bolt
3. Spanner
4. Outer blade washer
5. Lower guard
6. Lower guard lever
7. Upper guard
8. Blade
9. Inner blade washer
10. Dust port
11. Riving knife

SPECIFICATION

Input
No load speed
Bore size
Blade size
Cutting capacity
at 0 0
at 45 0
Bevel scale
Cord length
INSTRUCTIONS FOR SAFE HANDLING
The maximum permissible system impedance: Zmax for
ECS12519 is 0.245 Zref.
If in doubt, please verify with your local energy-utility that
the AC outlets in your area do not exceed the above
values.
STANDARD ACCESSORIES
Saw blade, Parallel fence, Spanner.
APPLICATION
Sawing wood.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can
exceed 85 dB. In this case, sound insulation and
hearing protection measures must be taken by the
operator.
12. Depth lock knob
13. Base plate
14. Depth of cut
15. Depth scale
16. Bevel adjustment knob
17. Bevel scale
18. Trigger switch
19. Safety button
20. Line guide
21. Depth adjustment lug
22. Livetool Indicator TM
1,250 W
4,500 min -1
16 mm
190 mm
66 mm
38 mm
0 - 45 0
4 m
ASSEMBLY INSTRUCTIONS
Be sure to disconnect the tool from the power
supply before attaching or removing the saw
blade. Be sure that the teeth of the saw blade are
pointing upward at the front of the tool.
ATTACHING AND REMOVING THE BLADE
(FIGURES 2, 3, 4, AND 5)
ATTACHING THE BLADE
1. Pressing the spindle lock button (1), turn the hex-head
bolt (2) with the spanner (3) until the spindle locks.
(Fig.2)
2. Loosen the hex-head bolt by turning the spanner
anticlockwise while pressing the spindle lock button.
(Fig.2)
3. Remove the hex-head bolt and the outer blade washer
(4). (Fig. 2)
4. Retract the lower guard (5) back with the lower guard
lever (6) as far as possible under the upper guard (7).
(Fig. 3)
5. Then, attach the saw blade (8) against the inner blade
washer (9) on the spindle. Then fit the outer blade
washer and the hex-head bolt. (Fig. 3 and 4)
6. Press the spindle lock button again, tighten the hex-
head bolt by turning the spanner clockwise while
pressing the spindle lock button. (Fig. 5)
7. After tightening the hex-head bolt, release the spindle
lock button.
REMOVING THE BLADE
1. Pressing the spindle lock button, turn the hex-head
bolt with the spanner until the spindle locks.
2. Loosen the hex-head bolt by turning the spanner
anticlockwise while pressing the spindle lock button.
3. Remove the hex-head bolt and the outer blade
washer.
4. Retract the lower guard back as far as possible under
the upper guard, then remove the saw blade.
ADJUSTING THE RIVING KNIFE (FIG. 6)
WARNING
Do not use saw blades the disk of which is
thicker or the set of which is smaller than the
thickness of the riving knife.
4