Azbox Elite User Manual page 70

3
Settings
3.8.1.8.2 USALS
This mode will allow you to use a DiSEqC 1.3/2.3 motor controlled by
USALS(Universal Satellite Automatic Location System).
The first time you select USALS, you must enter your location (longitude
and latitude). You can also edit the satellite's position. This will be
necessary if you add a new satellite because it will be set to zero by
default.
Select Go To Position option and press the OK( ) button in the
Command Mode to move the dish to the satellite position.
Select Go To 0 option and press the OK( ) button in the Command
Mode to move the dish to the 0 position.
NOTE
When scrolling through the satellite list in the Antenna Setup menu, the
dish will start to move when you highlight a satellite that has the
Positioner Setup set to DiSEqC 1.2 or USALS (assuming that a DiSEqC
1.2 or USALS motor is connected to your dish). You can avoid this by
returning the Positioner Setup to the OFF state.
70