Programming (Setting-Up) Your Odometer Odo - VDO CYTEC C 08 Installation And Operation Manual

13. Programming (setting-up) your odometer ODO

GB
You can enter individual odometer values into your VDO CYTEC C 10 at any time, i.e. transferring data from your old computer
C
into your new VDO CYTEC C 10 or after a battery change.
08
Watch out: after a battery change, your data for total ODO is reset to zero.
TIP: If you want to re-enter your totals after
a battery change, take down the value for
ODO before removing the battery.
Step 1: Call information for ODO into your
display.
Step 2: Start the set-up mode for odometer
by pressing the MODE 1 button for 5 sec.
MODE 1 5sec.
The last number is flashing.
MODE 1 5sec.
to quit
MODE 2 0,1sec. MODE 1 0,1sec.
to increase switch to next
Entering data is done by MODE 1 and MODE 2 buttons. (see set-up mode)
13