Vauxhall COMBO Owner's Manual page 185

7. Screw in wheel bolts and tighten slig htly,
inserting the wheel bolt wrench as far as
the stop.
8. Lower vehicle.
9. Tighten wheel bolts crossw ise, putting on
wheel bolt wrench as far as possible.
10. Align and engage hub cap or wheel
cov er 3 and wheel bolt caps 3 .
Before refitting the wheel cover clean
the wheel around the reta ining c lips.
Valve sy mbol 3 on back of wheel cover
m ust point towards valve on wheel.
Alloy wheels 3 : Put hub cap on and
engage, inserting pin on rear of hub
ca p into relevant hole in wheel.
Alloy wheels with anti-theft lock 3: Put
hub ca p on. Insert and tighten anti-
theft lock 3.
11. Close the jacking point flap on the
underside of the vehicle 3. Stow the
repla ced w heel – see page 176. Put
away the tools and warning triangle –
see pages 174, 178.
12. Check the pressure of the new ly
mounted ty re. Correct if necessa ry .
13. Have the tightening torque of the wheel
bolts on the new wheel checked on the
vehicle using a torque wrench as soon
as possib le and , if necessary, corrected.
Tightening torque – see page 243.
14. Replace the faulty tyre on the wheel
that was rem oved.
15. Replace the tem pora ry spare wheel 3
with a full specification wheel without
delay.
183