Fitting The Plinth - Zanussi ZU 9144 Instruction Booklet

PR167
7. Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm at
8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
PR168
8. Should the lining up of the furniture door be
necessary, use the clearance of slots. At the end of
operations, it is necessary to check if the door of
the furniture closes properly.
PR167/1
9. Fix cover (D) on guide (B) until it clips into place.
8mm
A
B
B
D
27

Fitting the plinth

Important
For the efficient operation of the appliance, it is
important that the original ventilation grid is
used.
S.I.007
For an opening height dimension A=820 mm and a
plinth height dimension a=100 mm, the plinth may
be fitted without adjustments. The same applies to
an opening height dimension B=870 mm and a
plinth height dimension b=150 mm.
For plinth heights greater than a=100 mm, b=150
mm, a cut should be made in the plinth, 580 mm
wide, in the centre of the appliance position,
leaving a remaining height of a=100 mm, b=150
mm.
Attach plinth to the kitchen units.
S.I.008
Important
The plinth must be positioned at a minimun
distance of 25 mm from the door.
25