Limbing And Pruning - Poulan Pro 2750 Operator's Manual

nd
Using a log for support
2
st
1
st
1 Cut
nd
2 Cut
Using a support stand
nd
2 Cut
st
1 Cut
st
1 Cut
nd
2 Cut

LIMBING AND PRUNING

WARNING:
Be alert for and guard
against kickback. Do not allow the moving
chain to contact any other branches or objects
at the nose of the guide bar when limbing or
pruning. Allowing such contact can result in
serious injury.
WARNING:
Never climb into a tree to
limb or prune. Do not stand on ladders, plat-
forms, a log, or in any position which can
cause you to lose your balance or control of
the saw.
IMPORTANT POINTS
S Work slowly, keeping both hands firmly
gripped on the saw. Maintain secure foot-
ing and balance.
S Watch out for springpoles. Springpoles
are small size limbs which can catch the
saw chain and whip toward you or pull you
off balance. Use extreme caution when
cutting small size limbs.
S Be alert for springback.
Cut
branches that are bent or under pressure.
Avoid being struck by the branch or the
saw when the tension in the wood fibers is
released.
S Keep a clear work area. Frequently clear
branches out of the way to avoid tripping
over them.
LIMBING
Cut
S Always limb a tree after it is cut down. Only
then can limbing be done safely and prop-
erly.
S Leave the larger limbs underneath the
felled tree to support the tree as you work.
S Start at the base of the felled tree and work
toward the top, cutting branches and
limbs. Remove small limbs with one cut.
S Keep the tree between you and the chain.
Cut from the side of the tree opposite the
branch you are cutting.
S Remove larger, supporting branches with
the cutting techniques described in BUCK-
ING WITHOUT A SUPPORT.
S Always use an overcut to cut small and
freely hanging limbs. Undercutting could
cause limbs to fall and pinch the saw.
PRUNING
WARNING:
shoulder height or below.
branches are higher than your shoulder. Get
a professional to do the job.
Make your first cut
S
through the bottom of the limb.
Next make a 2nd cut all the way
S
through the limb. Then cut a third
overcut leaving a 1 to 2 inch collar
from the truck of the tree.
Third cut
Collar
WARNING:
plug before performing maintenance except
for carburetor adjustments.
We recommend all service and adjustments
not listed in this manual be performed by an
authorized or Master Service Dealer.
12
Watch out for
Limit pruning to limbs
Do not cut if
of the way
1/3
Second cut
First cut
Pruning technique
SERVICE
Disconnect the spark