Addr Set Transmitter Address For Use In Poll-Mode; Open Temporarily Open Transmitter From Poll-Mode To Receive Serial Commands - Vaisala Humicap HMT310 User Manual

USER'S GUIDE____________________________________________________________________
38 _______________________________________________________________ M210619EN-C
ADDR Set Transmitter Address for
Use in POLL-Mode
Syntax: ADDR aa<cr>
where
aa = Address (0 ... 99)
Example:
>addr<cr>
Address : 0
>addr 1<cr>
Address : 1
OPEN Temporarily Open
Transmitter from POLL-Mode to
Receive Serial Commands
Syntax: OPEN nn<cr>
where
nn = Address of the transmitter (0 ... 99)
The OPEN command sets the bus temporarily in STOP-mode so that
the SMODE command can be issued.
Example:
>open 4<cr>
Device: 4 line opened for operator commands
>