Table of Contents
Advertisement
Installation
• The following instructions about
installation and maintenance must
be carried out by qualified
personnel in compliance with the
regulation in force.
• The appliance must be electrically
disconnected
interventions. If any electric supply
to the appliance is required to
carry out the work, ensure all the
necessary
followed.
• The side walls of the unit in which
the hob is going to be installed,
must not exceed the height of the
working top.
• Avoid installing the appliance in
the proximity of inflammable
materials (e.g. curtains, tea towels
etc.).
THE MANUFACTURER WILL NOT
ACCEPT LIABILITY, SHOULD ANY
OF
THE
OTHER
INSTRUCTIONS INCORPORATED IN
THIS
BOOKLET
REGULATION
IGNORED.
Gas connection
Choose fixed connections or use a
flexible pipe in stainless steel in
compliance with the regulation in force.
If using flexible metallic pipes, be careful
they do not come in contact with mobi-
le parts or they are not squeezed. Use
the same attention when the hob is
combinated with an oven.
before
precautions
SAFETY
OR
THE
IN
FORCE
IMPORTANT - To ensure a correct
operation, a saving of energy and the
long life of the appliance, the voltage
pressure of the appliance must
correspond to the recommended values.
The adjustable connection is fixed to the
comprehensive ramp by means of a
all
threaded nut G 1/2". Interpose the
sealing between the components as
shown in Fig. 6. Screw the parts without
forcing, adjust the connection in the
are
required direction and tighten everything.
IMPORTANT
Once installation is complete,
check the perfect seal of every
pipe fitting, using a soapy
solution, never a flame.
BE
A) Ramp with ending nut
B) Seal
C) Adjustable connection
Fig. 6
13
Advertisement
Table of Contents
