JVC CA-DXT99 Instructions Manual page 8

@
Speakers
To connect the speaker cords
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: blue/red/green/white to
(+) and black to (–).
From right front speaker (blue/black)
From right
subwoofer
(red/black)
From left subwoofer
(red/black)
From right surround
speaker (white/black)
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
• The front and center speakers are magnetically shielded to
avoid color distortions on TVs. However, if not installed
properly, it may cause color distortions. So, pay attention to
the following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV's main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
5
From left front speaker
(blue/black)
From center
speaker
(green/black)
From left surround
speaker (white/black)
Speaker layout
To enjoy multi-channel sound, locate the speakers as
follows. If you cannot locate like this, adjust the speaker
setting by using the SPK.SETTING menu (see page 37).
¤
To adjust the voltage selector
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing at the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
Voltage mark
DO NOT plug in before setting the voltage
selector and all connection procedures are
completed.