Advertisement
1. Parts Identification
Wiring Section
※:
When replace the gear motor assy.,joint,damper,spring,and casing assy.,please remove
joint first.Due to the position of joint is not unique,the machine will not work or gear motor
assy. would possibly damage if damper is installed in wrong position.
Figure 1
Please adjust the damper to heat
mode during installation.
When figure 2 is finished,put the gear motor assy. into the casing assy. One side of spring
shall be covered to the slot in damper,another side of spring shall be fixed into the slot in
casing assy. And cross-section of joint D should be matched with cross-section of damper
D.Move the damper after finished the installation, the damper will be come back to original
position automatically if installation correct.
Cross-section of joint D
Put the spring onto the joint
(Insert the spring to the joint's slot
and make sure that the spring is in
correct position,please refer to the
figure below).
Cross-section of damper D
Solt in damper
FV-07VFH3
Push
Spring
Solt in casing assy.
Figure 3
Figure 2
4
Advertisement
