Hdmi Connection - LG LH-RH9500TA Owner's Manual

HDMI connection

If you have a HDMI TV or monitor, you can connect it
to this recorder using a HDMI cable.
1. Connect the HDMI jack on the recorder to the
HDMI jack on a HDMI compatible TV or monitor
(H).
2. Set the TV's source to HDMI (refer to TV's Owner's
manual).
Notes:
When you use the HDMI connection, the audio's
sampling frequency is outputted only with 48KHz
even if you select [96KHz].
The arrow on the cable connector body should face
up for correct alignment with the connector on the
recorder.
(Type A)
If there is noise or lines on the screen, please check
the HDMI cable.
Audio Channel Selection
The Dolby Digital and DTS sound are not available
through the HDMI connection. Set the Dolby Digital to
PCM mode in the setup menu (refer to Audio Settings
on page 26).
Tip :
When you use HDMI connection, you can change the
resolution (576i, 576p) for the HDMI output by setting
the [Progressive Scan] option in the setup menu.
(See page 25)
Progressive Scan ON mode: 576p
Progressive Scan OFF mode: 576i
The recorder does not support 720p and 1080i
resolutions for HDMI.
Caution
Changing the Progressive Scan mode when the
recorder is connected with HDMI connector may result
in malfunctions. To solve the problem, turn off the
recorder and then turn it on again.
HDMI compatible TV
Rear of the HDD/DVD Recorder Receiver
About HDMI
HDMI (High Definition Multimedia Interface) supports
both video and audio on a single digital connection for
use with DVD Players, Set-Top Boxes, and other AV
devices.
HDMI was developed to provide the technologies of
HDCP (High Definition Contents Protection). HDCP is
used to protect digital content transmitted and
received.
HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of
HDMI licensing LLC.
Additional Information for HDMI
When you connect a HDMI or DVI compatible
device make sure of the followings:
- Try switching off the HDMI/DVI device and this
recorder. Next, switch on the HDMI/DVI device
and leave it for around 30 seconds, then switch
on this recorder.
- The connected device's video input is set
correctly for this unit.
- The connected device is compatible with
720(1440)x576i or 720x576 progressive video
input.
Not all HDCP-compatible DVI devices will work with
this recorder.
- It's impossible copy protected-DVD title's
playback in non-HDCP devices.
HDMI
H
13