Sub-Ts8 Subwoofer Amplifier Panel Controls And Connections - Harman Kardon HKTS 8 Owner's Manual

SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS

SUBWOOFER
¡
FILTER
ON
™
MIN
OFF
£
ON
AUTO
¢ REVERSE
NORMAL
∞
SUB
LINE
LEVEL
IN
§
L
H
I
G
H
¶
L
E
V
E
L
R
•
OUT
ª
IMPORTANT: CONNECT STRIPED WIRE
TO RED ( ) SPEAKER TERMINAL.
‚
¡ Subwoofer-Level Control
™ High-Cut (Low-Pass) Filter Switch
£ Music-Sense On/Off Switch
¢ Phase Switch
¡ Subwoofer-Level Control: Volume
may be adjusted using the Subwoofer-
Level Control. Turn the control clockwise
to increase the SUB-TS8's volume, or
counterclockwise to decrease it.
™ High-Cut (Low-Pass) Filter Switch:
Placing switch in the ON position activates
circuitry that cuts out all audio input signals
above 120Hz. This allows the SUB-TS8
to focus its power on reproducing the low-
frequency portion of the signal, avoiding
SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
LEVEL
MAX
PHASE
L
R
IN
∞ Line-Level Subwoofer (SUB) Input
§ Line-Level Full-Range Inputs
¶ Speaker-Level Outputs
• Speaker-Level Inputs
inefficiency and distortion. Engage this filter
when using the Speaker-Level Inputs •,
or when using the Line-Level Full-Range
Inputs §, unless your receiver or processor
processes its line-level output using a low-
pass filter. The filter has no effect when the
SUB Input ∞ is used.
£ Music-Sense On/Off Switch: When
placed in the AUTO position, and when the
Master Power Switch ª is turned on, the
SUB-TS8 will automatically turn itself on or
SUB-TS8 For use with
HKTS 8 System
C A U TIO N C A U TIO N
R ISK OF ELEC TR IC SH O C K R ISK OF ELEC TR IC SH O C K R ISK OF ELEC TR IC SH O C K
D O NO T OPE N D O NO T OPE N D O NO T OPE N
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE
AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME
TYPE T 2.5A L/250V
POWER
AC 120V~60Hz
ª Master Power Switch
‚ AC Power Cord
place itself in the Standby mode, depending on
whether it is receiving an audio signal. When
this switch is placed in the ON position, the
SUB-TS8 will remain on, whether or not it is
receiving an audio signal.
An LED located on top of the SUB-TS8 indi-
cates whether the SUB-TS8 is in the ON or
STANDBY state when used with the Music-
Sense On/Off Switch £ in the AUTO
position. The LED is lit blue to indicate that
the SUB-TS8 is receiving an audio signal
5