Harman Kardon HS 350 Owner's Manual page 30

Remote Control
Example: To program the Macro 1
so that it turns on the HS 350 and your TV,
follow these steps:
• Press the Macro 1 button and Mute
buttons at the same time and then release
them.
• Note that the Program Indicator will flash
amber.
• Press the TV Selector .
• Press the Mute button to store the HS's
power on command.
• Press the Screen Power On button
button to store the TV Power On Command.
M N KL
• Press the button
the process and store the macro sequence.
After following these steps, each time you press
the Macro 1 button , the remote will send
all Power On commands.
30 REMOTE CONTROL
button Erasing Macro Commands
To remove the commands that have been
programmed into one of the Macro buttons,
follow these steps:
1. Press the Mute button
button that contains the commands you
wish to erase.
2. Note that the Program Indicator
flash amber, and the red LED under the Input
Selector last used will turn on.
3. Within ten seconds, press the Mute button
.
4. The red LED under the Selector will go out,
to complete
and the Program Indicator
green and flash three times before it goes out.
5. When the Program Indicator
the Macro has been erased.
and the Macro
will
will turn
goes out,