EMU26312
Tilt lock mechanism
The tilt lock mechanism is used to prevent the
outboard motor from lifting out of the water
when in reverse gear.
1. Tilt lock lever
To lock it, set the tilt lock lever in the "
(lock) position. To release, push the tilt lock le-
ver in the " " (release) position.
EMU26320
Tilt support knob
To keep the outboard motor in the tilted up po-
sition, push the tilt support knob under the
swivel bracket.
EMU26330
Tilt support bar
The tilt support bar keeps the outboard motor
in the tilted up position.
Basic components
EMU26360
Power tilt unit
This unit tilts the outboard motor up and down
and is controlled with the power tilt switch.
ECM00630
CAUTION:
"
Do not step on or exert pressure on the
power tilt motor. The power tilt unit could
be damaged as a result.
1. Power tilt unit
2. Power tilt motor
EMU26382
Top cowling lock lever (pull up type)
To remove the engine top cowling, pull up the
lock lever(s) and lift off the cowling. When in-
stalling the cowling, check to be sure it fits
properly in the rubber seal. Then lock the
cowling by moving the lever(s) downward.
21