Troubleshooting Chart - Sharp CD-MPS660H Operation Manual

" Headphones
! Before plugging in or unplugging the headphones, reduce the
volume.
! Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
! Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.

Troubleshooting chart

Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
" General
Symptom
! The clock is not set to the ! Did a power failure occur? Reset
correct time. the clock. (Refer to page 12.)
! When a button is pressed, ! Set the unit to the power stand-
the unit does not respond. by mode and then turn it back on.
! If the unit still malfunctions, reset
it. (Refer to page 42.)
! No sound is heard. ! Is the volume level set to "0"?
! Are the headphones connected?
! Are the speaker wires discon-
nected?
" CD player
Symptom
! Playback does not start. ! Is the disc loaded upside down?
! Playback stops in the mid- ! Does the disc satisfy the stan-
dle or is not performed dards?
properly.
! Is the disc distorted or
scratched?
! Playback sounds are ! Is the unit located near excessive
skipped, or stopped in the vibrations?
middle of a track.
! Is the disc very dirty?
! Has condensation formed inside
the unit?
03/12/19 CD-MPS660H(H)E4.fm
CD-MPS660H
ENGLISH
Possible cause
Possible cause
E-40
TINSZA035AWZZ
8