Recording To A Cassette Tape - Sharp CD-G7500DVD Operation Manual

Recording to a cassette tape (continued)
CD-G7500DVD
CP-G7500
ENGLISH
Dubbing from tape to tape
H
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette
compartment. Insert a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as the
master tape.
3
Press the TAPE (1 V 2) button
until "TAPE 1" appears on the
display.
The reverse mode will be set to " ".
4
Press the I6 button.
Recording will be paused.
5
Press the 0 button to start dubbing.
To stop dubbing:
Press the H button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
H
1. Load the tape to be erased into the TAPE 2 cassette compartment with the
side to be erased facing toward you.
2. Press the TAPE (1 V 2) button until "TAPE 2" appears on the display.
3. Set the button to " " to erase only one side and to "
sides.
4. Press the I6 button.
5. Press the 0 button to erase side A, or the 1 button to erase side B.
To erase both sides, begin with side A. (If erasing is started from side B, the
tape will not switch over to side A.)
Note:
Make sure that the TAPE 1 is not in use.
E-65
*CD-G7500DVD(EN)60-65 65
" to erase both
05.1.13, 14:45
CD-G7500DVD (S)
TINSZA159AWZZ
1
2
3
4
5
6
7
8
9
10