Memorising A Station - Sharp CD-E500H Operation Manual

" Memorising a station

You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 15.
2
Press the MEMORY/SET button to enter the preset tuning
saving mode.
3
Within 30 seconds, press the PRESET (
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store
that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or if the AC lead is discon-
nected.
" To recall a memorised station
Press the PRESET (
select the desired station.
" To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
1 Press and hold down the PRESET (
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 When the desired station is located, release the PREEST (
) button.
or ) button to
" To erase entire preset memory
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the TUNER (BAND) button and the DISC
SKIP button, press the ON/STAND-BY button until "TUNER CL"
appears.
03/1/9
or ) button for less than 0.5 seconds to
or ) button.
or
CD-E500H(H)E2.fm
CD-E500H
ENGLISH
8
E-16