Sharp CD-E100H Operation Manual page 29

6
Within 30 seconds, press the TUNER PRESET (
ton to specify the minute to start, then press the MEMORY
button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback:
Press the ON/STAND-BY button to turn the power on.
8
When the preset time is reached, playback will start.
9
It will enter the power stand-by mode one hour after the
timer playback starts.
To reset or change the timer setting:
Perform "Timer playback" from the beginning.
Note:
Once the time is set, the setting will be retained until a new time is
entered.
Caution:
Do not turn the volume up too high. Playback starts at the volume
set before entering the timer stand-by mode.
Sleep operation
T
or ) but-
1
Play back the desired sound source.
2
Press the SLEEP button.
To change the sleep time:
Press the SLEEP button repeatedly to select the desired sleep
time. The time will decrease as follows.
The amount of sleep time can also be changed whilst in the
sleep mode.
3:00
(cancel) 0:05
3
Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst the sleep timer is set.
To confirm the remaining sleep time:
Press the SLEEP button whilst the sleep timer is set.
The remaining sleep time is displayed for about 3 seconds.
Note:
When you use the sleep operation with a cassette, set the sleep
time longer than the remaining playback time of the cassette. If the
unit enters the stand-by mode before the cassette reaches its end,
the cassette mechanism or the tape may be damaged.
03/1/21
2:00 1:30 1:00
0:10 0:15 0:30
08-CD-E100H(H)E3.fm
CD-E100H
ENGLISH
8
E-22