Lincoln 2014 MKZ Owner's Manual page 258

Refer to your scheduled maintenance
information for scheduled intervals for fluid
checks and changes. Your transmission
does not consume fluid. However, the fluid
level should be checked if the transmission
is not working properly, (For example: if
the transmission slips or shifts slowly) or if
you notice some sign of fluid leakage. See
Scheduled Maintenance (page 413).
Do not use supplemental transmission fluid
additives, treatments or cleaning agents.
The use of these materials may affect
transmission operation and result in
damage to internal transmission
components.
6F50/6F55 Transmission
WARNINGS
The dipstick cap and surrounding
components may be hot; gloves are
recommended.
Use gloves when moving the air filter
assembly. Components will be hot.
Note: Automatic transmission fluid
expands when warmed. To obtain an
accurate fluid check, drive the vehicle until
it is warmed up (approximately 20 miles
[30 kilometers]). If your vehicle has been
operated for an extended period at high
speeds, in city traffic during hot weather
or pulling a trailer, the vehicle should be
turned off until normal operating
temperatures are reached to allow the
fluid to cool before checking. Depending
on vehicle use, cooling times could take
up to 30 minutes or longer.
MKZ (CC9) , enUSA
Maintenance
Refer to your scheduled maintenance
information for scheduled intervals for fluid
checks and changes. Your transmission
does not consume fluid. However, the fluid
level should be checked if the transmission
is not working properly. For example, if the
transmission slips or shifts slowly or if you
notice some sign of fluid leakage.
1. Drive the vehicle 20 miles (30
2. Park the vehicle on a level surface and
3. With the parking brake engaged and
(If Equipped)
4. Put the gearshift lever in P (Park) and
Note: You will need to move the air filter
assembly to access the transmission
dipstick.
5. Remove the dipstick, wiping it clean
6. Install the dipstick making sure it is fully
7. Remove the dipstick and inspect the
255
kilometers) or until it reaches normal
operating temperature
engage the parking brake.
your foot on the brake pedal, start the
engine and move the gearshift lever
through all of the gear ranges. Allow a
minimum of 10 seconds for each gear
to engage.
leave the engine running.
with a clean, dry lint free rag. If
necessary, refer to Under hood
overview in this chapter for the location
of the dipstick.
seated in the filler tube by turning it to
the locked position.
fluid level. The fluid should be in the
designated areas for normal operating
temperature.