Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Siemens ET6 Series Instruction Manual

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

Controls for
# main switch
0 timer
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
$ Single-circuit hotplate
ð Dual-circuit hotplate
ò Tri-circuit hotplate
æ Extended cooking zone
< Halogen hotplate
< Halogen hotplate and › (boost), with power
setting
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
Displays for
timer
wipe protection
extended cooking zone
Activating and deactivating
Touch the ð symbol
Touch the ò symbol; 2nd filament circuit is activated
Touch the ò symbol again; 3rd filament circuit is activated
Touch the æ symbol
Note: do not look into the halogen light as the glare may dazzle the eyes
Set hotplate 9, touch 9 again in the settings area. › lights up in the display
Displays for
heat setting‚-Š
residual heat •/œ
Settings range
for setting the
hotplate
for setting the timer
Note: Always keep the controls dry. Moisture reduces their
effectiveness.
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to œ. The display remains lit until the hotplate has
cooled sufficiently.
Controls for
hotplate
triple-circuit
hotplate
dual-circuit
hotplate
' electronic
boil start control
5