Quick Guide; Attaching The Stand; Setting The Tv - Sharp Aquos LC-32RA1E Operation Manual

Quick guide

Attaching the stand

Before performing work spread cushioning over the base area to lay the TV on, making sure the
area is completely flat. This will prevent it from being damaged.
Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
1
Confirm the 8 screws supplied with the TV.
Short screws (m4)
(used in step 2)
3
Insert the stand into the opening on the bottom of
the TV.
NOTE
• To detach the stand, perform the above steps in reverse order.

Setting the TV

Ferrite Core
The Ferrite Core should be permanently attached
and never removed from the AC cord.
Standard DIN45325
plug (IEC 169-2)
75-ohm coaxial cable
Cable clamp
(large)
Bundle the cables with the clamp (large).
Setting the TV on the wall
• This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (See page 23.) The
use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• When you use the AN-37AG2 (SHARP) wall mount bracket, set the angle of the TV to 0° or 5°. Do not set the angle
to more than 10°.
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
Long screws (m4)
(used in step 4)
Cable tie
2
Attach the two parts of the stand unit to each other
using the 4 short screws as shown.
4
Insert and tighten the 4 long screws on the rear
of the TV as shown.
Bundle the AC cord with
the clamp (small).
Ferrite Core
Cable clamp (small)
Place the TV close to the
AC outlet, and keep the
power plug within reach.
Product shape
varies in some
countries.
AC cord
3