Sharp AQUOS LC-15E2E Operation Manual page 37

AV Connections (Continued)
[2] For programmes
• The influence of the AV control voltage and of fast blank at programme positions from 1 to 199
can be set.
• When connecting a video device to the AV1 terminal, you need to adjust the decoder programme
settings.
</>
T
SUBPAGE
END
E
OK
SOUND MENU
MENU
M
]/[
CH
OK
TV/VIDEO
1
Perform steps 1 and 2 in
[1] AV1/AV2 to display the "AV
connections" screen.
2
Press ]/[ to select "For
programmes", and then press OK
to display the "For programmes"
screen.
3
Press ]/[ to select the "AV
control voltage" or "RGB on-
screen display".
4
Press </> to select "yes" or "no".
Note:
• If the item concerned is set to "yes",
the appropriate picture is through-
connected at all programme
positions from 1 to 199 when a
control voltage/an RGB signal is
applied.
5
Press ]/[ to select "For decoder
connected to AV1", and then
press OK to display the decoder
programme selection screen.
6
Press ]/[ and/or </> to select
the programme for the decoder,
and then press OK. Repeat the
same procedure if you want to
specify other decoder
programmes.
7
Press MENU to return to the "For
programmes" screen.
8
Press ]/[ to select "Sound from
AV1", and then press </> to
select the desired sound source.
9
Press END to exit.
Useful Features (Continued)
0
0
0
0
0
0
0
0
0
0
0
0
35