Water Drainage; In The Interest Of The Environment - Tricity Bendix WDR1020 Operating And Installation Instructions

Water drainage

If you intend the drain hose from the machine to empty
into a sink, make sure that the sink is empty and that the
plug hole is not blocked.
If the machine is permanently plumbed in, hook the end
of the hose into a standpipe installed for the purpose.
The standpipe must have an internal diameter of at least
40 mm (1 1 / ") in order that there is an air gap between
2
the drain hose and the standpipe. Make sure, that it is
designed in such a way, that the end of the drain hose
cannot be covered with water.
3 pin
P0376
Important
Before connecting up the machine to new pipework or to
pipework that has not been used for some time, run off a
reasonable amount of water to flush out any debris that
may have collected in the pipes.
Whether discharging into a sink or a standpipe check
that the end of the drain hose is neither too high nor too
low. The top of the curve in the hose's end should be no
more than 90 cm (35.4"), and no less than 60cm (23.6")
above floor level.
Levelling
P0850
prevents vibration, noise and displacement of the ma-
chine during operation.
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
Special conditions
If the floor is carpeted with a deep-pile carpet or covered
with crumbly or soft material, insert a rigid support base
under the feet to prevent noise, vibration or displace-
ment. The base should protrude a few centimetres
beyond the edges of the machine.
40 mm
inside dia min
600 mm min
900 mm max
Level the washing ma-
chine by raising or low-
ering the feet. The feet
may be tight to adjust as
they incorporate a self
locking nut, but the
machine MUST be level.
Any necessary adjustment
can be made with a span-
ner. Accurate levelling
Warning
The machine should NOT be placed on deep pile car-
peting.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a break-
down.
All plumbing and electrical work required to install this
appliance must be carried out by competent persons or
qualified plumbers or electricians.

In the interest of the environment

Washing machines and dishwashers should be connect-
ed to the FOUL drainage system, the water will then be
taken to a sewage works for treatment before being dis-
charged safely into a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is dis-
charged directly into a river or stream and may cause
pollution.
If you require any further advice please contact your
local authority drainage department.
SHOWER
BATH
WASHING
MACHINE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
P0987
SINK TOILET
BIDET
DISHWASHER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
TREATED
DISCHARGE
RIVER
5