Maintenance And Cleaning - Tricity Bendix WDR1020 Operating And Installation Instructions

Front-loading washer
Table of Contents

Advertisement

MAINTENANCE AND CLEANING

Before any maintenance or cleaning is carried out you
must DISCONNECT the appliance from the electricity
supply.
Descaling
The water we normally use contains lime. It is a good
idea to periodically use a water softening powder in the
machine. Do this separately from any laundry washing,
and according to the softening powder manufacturer's
instructions. This will help to prevent the formation of
lime deposits.
After each wash
Leave the door open for a while. This helps to prevent
mould and stagnant smells forming inside the appliance.
Keeping the door open after a wash will also help to pre-
serve the door seal.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the dispenser drawer
From time to time the washing powder and additive dis-
penser drawer should be cleaned.
Remove the drawer by pressing the catch downwards
and by pulling it out. Flush it out under a tap, to remove
any traces of accumulated powder.
C0023
Cleaning the drawer recess
P0038
any clothes in the drum.
C0027
Having removed the draw-
er, use a small brush to
clean the recess, en-sur-
ing that all washing pow-
der residue is re-moved
from the upper and lower
part of the recess.
Replace the drawer and
run the rinse programme
for a few minutes without
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
Turn off the water taps.
Select a wash programme and run for a few sec-
onds.
Unscrew the inlet hoses.
Unhook the drain hose from the rear support and
position the end in a bowl. Run the draining pro-
gramme for a few seconds.
When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
17

Advertisement

Table of Contents
loading

Table of Contents