Power And Sound Controls - Panasonic CQ-RD243N Operating Instructions Manual

Power and Sound Controls

E
N
G
L
I
Power
S
H
Turn the key in the ignition until the accessory
3
indicator lights.
Power on : Press [PWR].
Power off : Press [PWR] again and hold.
Volume
Up
Down
Volume Level (0 to 40)
CQ-RD243
APM
MUTE MUTE 1
Mute
Press [MUTE] to mute the sound.
Press [MUTE] again or turn [VOL] to cancel.
MUTE
MUTE indicator
6
CQ-RD243N
Note: When the power is switched on
for the first time, a demonstration mes-
sage appears on the display.
To cancel this display, press [DISP].
Demonstration message
Remote Control Sensor (REMOTE)
REMOTE
PTY
TUNE
TRACK
CT
A F
DISC SCAN REPEAT RANDOM
MTL NR 2 3 TPS REP 4 5 B S 6 T A
Loudness (LOUD)
Press and hold [MUTE] (LOUD) for more than 2
seconds to enhance bass and treble tones at low or
medium volume.
Press and hold [MUTE] (LOUD) again to cancel.
LOUD
Loudness indicator
Note: If no operation takes place for more than 5 seconds in audio mode (2 seconds in Volume mode), the display return
to Regular Mode.
Audio Mode (Bass/Treble/Balance/Fader)
q
Push [SEL] to select the audio mode.
Regular Mode
PUSH
Volume
Bass
Treble
Balance
Fader
CQ-RD243
APM
DISC
MUTE 1 MTL NR
w
Turn [VOL] to change each level.
Bass
Treble
Up
Down Balance
Fader
Note: If the fader is set to front, the pre-
amp output (rear) is decreased.
REMOTE
PTY
TUNE
TRACK
CT
A F
SCAN REPEAT RANDOM
2 3 TPS REP 4 5 B S 6 T A
(–12 to +12 dB by 3 dB step) default : 0 dB
(–12 to +12 dB by 3 dB step) default : 0 dB
(Left / Right: 1 to 15)
default : CNT (Centre)
(Front / Rear: 1 to 15)
default : CNT (Centre)
CQ-RD243N
E
N
G
L
I
S
H
4
7