Panasonic AW‑HE60HN Operating Instructions Manual page 11

How to install and connect the unit
6
Connect the rear panel connectors.
Anchor the AC adaptor cable in place using the cable clamp.
q How to secure the AC
p
adaptor cable
1 Loosely secure the cable
clamp.
Cable clamp
Loosely secure the cable
clamp in the area shown
above.
2 Fasten the cable clamp.
Strap part
Take hold of the strap part, slide
the cable clamp until it stops
moving, and then secure it tightly.
7
Attach the cable cover.
p  Fit the two tabs on the cable cover into the square mounting hole at either side of the rear panel.
p  Secure the cable cover using the screw (M3  20 mm) provided.
Screw diameter
M3
Note
p  Engage the tabs on the cable cover so they fit into place perfectly, and check that the cover is not rickety.
Clamping torque
0.78 N · m {8 kgf · cm}
(continued)
[AW-HE60H]
Tab (one at either side)
[AW-HE60S]
Tab (one at either side)
Square hole (one at either side)
LAN cable
Video output
cable
Interface cable
AC adaptor cable
Screw for cable cover (M3 screw)
(with flat washer, spring washer)
Square hole (one at either side)
LAN cable
Coaxial cables
Interface cable
AC adaptor cable
Screw for cable cover (M3 screw)
(with flat washer, spring washer)
11