How To Use The Built-In Timer - Sharp XL-530H Operation Manual

HOW TO USE THE BUILT-IN TIMER

Timer playback
1
3
2
4,5,6
TIMER
3
4
5
6
Before setting the timer, make sure that the clock
setting is correct. (Page 6)
1
Press the ON/STAND-BY button to turn the
power on.
2
Press the FUNCTION button to select the desired
function, and then adjust the sound volume using
the VOLUME control.
2,5,6
3
Press the CLOCK/TIMER/SLEEP button repeat-
f
edly until "
4
Within 6 seconds, press the MEMORY/SET but-
ton.
If more than 6 seconds have passed, start again
from step 3.
5
Turn the jog dial to set the hour at which to start,
and then press the MEMORY/SET button.
6
Turn the jog dial to set the minute at which to
start, and then press the MEMORY/SET button.
The timer playback starting time, function, and vol-
ume will be displayed, and then the unit will enter
the stand-by mode automatically.
f
" " will appear and the current time will be dis-
played.
7
When the preset time is reached, the volume will
increase gradually until it reaches the volume you
were listening to before the unit went into the
stand-by mode.
8
If you select CD or TAPE during timer playback,
the unit will enter the stand-by mode after the
tape or CD is finished playing back. If you select
TUNER, the unit will enter the stand-by mode
one hour later.
Caution:
Timer recording is not possible.
Recording operations are not possible during timer
playback.
To make a recording, stop the timer playback.
To confirm the timer setting:
Press the CLOCK/TIMER/SLEEP button on the main
unit twice or press the TIMER button on the remote
control once.
The timer playback starting time, function, and vol-
ume will be displayed.
If you press the TIMER button on the remote con-
trol whilst confirming the timer setting (whilst "
is flashing), you can turn the timer playback stand-
by mode on or off.
To change the programmed contents:
After cancelling the timer mode, perform steps 1
- 6 above.
To cancel timer operation:
Press the ON/STAND-BY button to turn the
power on.
Note:
The previously programmed timer starting time
will be stored until it is reprogrammed.
14
" is displayed.
f
"