Table of Contents
Advertisement
10. Swing the Wire Feed Swing Arm (36)
closed, and swing the Feed Tensioner
(37) across the tip of the Arm, to latch it.
Make sure the Welding Wire is resting
in the top groove of the Feed Roller
(34), then turn the Feed Tensioner knob
clockwise a couple of turns.
After the wire is held by the Tensioner,
you may release it.
11. Pull the Nozzle (3) to remove it.
12.
Using the third oval hole on the Multi-
wrench (43), turn the Contact Tip (2b)
counterclockwise and remove.
13.
Lay the Gun Cable out in a straight line
so that the wire moves through it easily.
Leave the cover open, so that the feed
mechanism can be observed.
14. Do not touch the Gun's Trigger (1c).
Plug the Power Cord into its electrical
outlet and turn the welder ON.
Page 12
For technical questions, please call 1-800-444-3353.
Feed Swing
Arm (36)
The following steps require applying power to the welder
To prevent serious injury from fire or electric shock:
1.
do not touch anything, especially not the ground clamp,
with the gun or welding wire or an arc will be ignited.
2.
do not touch internal welder components while it is
plugged in.
Feed
tensioner (37)
nozzle
(3)
contact
tip (2b)
WARnIng
with the cover open.
gun
5
4
3
2
1
0
WIRE-FEEd SPEEd
90 AMP FLUX WIRE WELdER
gun
6
MIn
On
7
8
9
MAX
OFF
10
120 V~
60 hz
SKU 98871
Hide quick links:
Advertisement
Table of Contents
