Mitsubishi Electric UD8900U User Manual page 35

Menu operation (continued)
INSTALLATION 2 menu
ITEM
AUTO POWER ON
AUTO POWER OFF
SCREEN
IMAGE CAPTURE
SPLASH SCREEN
BACK COLOR
DVI LONG CABLE
REMOTE 1 MODE
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
PIN 9
RESET
FILTER MENU
CLEANUP PERIOD
MANUAL CLEANUP
SPLASH ID SCREEN to enable the password lock.
may remain on the screen. Consult your dealer in this case.
1 1
INSTALLATION 2
AUTO POWER ON
AUTO POWER OFF
SCREEN
IMAGE CAPTURE
SPLASH SCREEN
ON
BACK COLOR
DVI LONG CABLE
REMOTE 1 MODE
FILTER MENU
SETTING
ON / OFF
OFF / 5min-8hour
16:10
16:9
4:3
SETUP
ON / OFF
BLUE / BLACK /
IMAGE
AUTO
MANUAL
ENTER
GND
POWER / NONE
COMPUTER 1
COMPUTER 2
VIDEO
S-VIDEO
DVI
BLANK / NONE
ON/OFF
OK
ENTER
24H / 1 WEEK /
OFF
OK
opt.
2 2
OFF
5min
16:10
SETUP
ON
BLUE
AUTO
ENTER
ENTER
FUNCTION
When ON is chosen, the projector is automatically turn on when the power
cord is plugged in the wall outlet. Choose ON when using the projector
mounted on the ceiling.
remote control to turn on the lamp.
When no video signal is input and no operation is made, the projector
automatically turns off after the selected time period. A dialog is displayed 5
minutes before the projector turns off.
Select this setting when using a 16:10 screen.
Select this setting when using a 16:9 screen.
Select this setting when using a 4:3 screen.
Use to capture the screen for the splash screen. (See page 57.)
Choose ON to display the splash screen when the power is turned on.
Use to select the background from among BLUE, BLACK and IMAGE, which
will be displayed when there is no signal input from the source. When IMAGE
is selected, the splash screen will be displayed.
Select this option for normal use.
Use to adjust the amount of transmission signal correction when a long DVI
cable is used.
Select when controlling the projector by a control panel connected to the
REMOTE 1 IN terminal. (See page 63.)
Unchangeable. (Fixed.)
Select POWER or NONE.
You can assign COMPUTER 1, COMPUTER 2, VIDEO, S-VIDEO, DVI, HDMI,
SDI (for UD8900U only), or NONE to each pin. Though the assignment can
be duplicated, the pins so assigned become invalid and their settings are
displayed with asterisks at both ends (like "*COMPUTER 1*").
Select BLANK or NONE.
Unchangeable. (Fixed.)
Settings are reset to the defaults.
The filter menu for the following settings is displayed.
You can set the filter cleaning interval. (See page 67.)
Select this option to clean the filter immediately.
EN-35