Special programmes
Fluff Clean
?
This programme is executed to clean the drying circuit of any fluff
deposits. The time at which the programme needs to be run is determined
automatically by the washer-dryer and indicated by the (Fluff Clean)
symbol on the display panel. The
the programme has been successfully completed.
To run the Fluff Clean
Make sure that the drum is completely empty and close the door.
Set the programme selector to Fluff Clean
!
Press the
(Start/Pause) button.
At the end of the programme, the Fluff Clean
You can also run the Fluff Clean
i
prompting from the appliance.
' + B Rinse + Spin
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 13.
t
+ B Empty + Spin
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 13.
Turn the programme selector to
Set the spin speed to $ (Rinse stop).
!
Press the
(Start/Pause) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to
Press the B (Spin) button repeatedly until the desired spin speed is
set.
!
Press the
(Start/Pause) button.
l
(Fluff Clean) symbol remains lit until
l
programme, proceed as follows:
?
programme at any time without
:
:
t
+ B
Empty + Spin.
t
+ B
Empty + Spin.
?
.
?
symbol goes out.
l
12