Table of Contents
Advertisement
SETTING UP YOUR TV
o
Press OK. If your country supports Network Guide,
The Guide Type screen will appear.
TV Guide Selection
Electronic Program Guide accessed by the "GUIDE" key of your
remote control:
Select "MediaGuide" if you want to use the advanced rich media
EPG provided through the network.
*Your TV must be connected to the network.
Select "Broadcast Guide" if you want to use the simple EPG
provided by our local broadcast network, if any.
Broadcast Guide
C
c
Press
or
to select Broadcast Guide or
MediaGuide.
NOTE: If you select MediaGuide, it may take time to
access the Guide screen depending on active channel
numbers.
p
Press OK. If the Ant/Cable screen appears, press
b
to select Antenna or Cable, and then press OK to
check (
).
Ant/Cable
Antenna
Cable
Next
q
Select Next and press OK. The Auto Tuning start up
screen will appear with the option to select between
DTV and ATV, DTV or ATV if available. Use
select the appropriate mode.
r
B
b
Press
or
to highlight Start Scan, and then press
OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will indicate
the scan status.
You must allow the television to complete the
search.
Auto Tuning - Antenna
Progress
DTV Tune
3 %
ATV Tune
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total number
of services found.
B
C
or
Found
2
Waiting...
Channel
: C7
s
C
Press
or
(analogue channel) lists.
T
B
Use
or
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
PLEASE NOTE
or
The Quick Setup menu can also be accessed at any
time from the Setup / System Setup menu.
Ant/Cable (if available)
From this menu, you can set the RF input configuration.
a
Press MENU /
b
B
Press
/
press OK.
c
to
c
b
Press
to select Ant/Cable and press
select Antenna or Cable.
NOTE: When you attempt to change the Ant/Cable
setting, a warning message will appear followed by
PIN entry (if PIN has been set) and a prompt for Auto
Tuning.
d
When Ant/Cable is set to Cable, the following setting
options will be provided in the Auto Tuning screen.
B
Press
or
select your desired option.
Auto Tuning - Cable
Tuning Mode
DTV
Operator Selection
Scan Type
Start Frequency
End Frequency
Modulation
Symbol Rate
Network ID
18
c
to view the DTV (digital channel) or ATV
b
to move through the list to select a
C c
to highlight Setup icon.
C c
to highlight System Setup icon and
b
to select an item and press
DTV and ATV
Start Scan
Others
Quick Scan
Auto
Auto
Auto
Auto
Auto
C
c
or
to
C
c
or
to
Advertisement
Table of Contents
