Charging The Battery - Gigaset L410 User Manual

Registration failed
u A negative confirmation tone is emitted (sequence of tones falling in pitch).
u If the device cannot be registered within 5 minutes, it switches off.
¤
If the registration was not successful, try again.
¤ If necessary, switch on the device again. It is immediately ready for registration.
¤
Check whether the registration PIN on the base is set to 0000.
¤
Move closer to the base with the Gigaset L410.
£
If the device is already registered to another base, you must de-register it
( page 10). Following this, it will be ready for registration again.
Securing the clip
¤
Attach the Gigaset L410 to
your clothing using the clip.
Optimal distance from your
mouth: 20 cm

Charging the battery

When delivered, the battery is partly charged. When the device is registered and
on stand-by, the charge status is shown as follows:
Device
In the charging cradle
Not in the charging
cradle
In all other operating conditions, (
means of the LED.
When the battery is almost empty, a signal tone is always emitted, 1 x per min.
¤
To charge the battery:
Connect the charging cradle to the mains
power and place the device in the charging
cradle .
It will be fully charged within 2.5 hours. You can
interrupt the charging procedure.
Note: If you place the device in the charging cradle
during a call, this will not disconnect the call.
Battery status
Fully charged
Charging
Sufficient charge
Almost empty
£
page 2) the charge status is not displayed by
LED
Steady green light.
Steady red light.
Flashes green, every 5 seconds
Flashes red, every 5 seconds
6