Gigaset L410 User Manual page 7

Closing the battery cover
¤
Insert the cover at the bottom end
of the casing.
¤
To open the cover again:
Loosen the catch and lift the cover upwards.
Registering the device with the base
In order to telephone using your Gigaset L410, it must be registered with your
telephone's base. If you purchased the device in a set with a Gigaset telephone, it
is already registered.
Note
The Gigaset L410 uses 0000 as its PIN for registration. When you have set another PIN
on your base, you must reset this to 0000 to enable registration of the L410. After
registration you can change the PIN again.
As soon as you have inserted the battery, the device becomes ready for
registration for a 5 minute period. The LED indicates readiness for registration
by flashing (green, 3 x per second).
Following this, the device switches off. When you switch the device on again (by
pressing the answer/end call key for at least 3 seconds) it is ready for registration
¤
again.
¤
For registration, stand close to your telephone's base.
Start the registration process with the base as described in your base's
operating instructions (on most DECT telephones by holding down the paging
key); the base will take up to one minute to complete registration.
Device successfully registered
u The LED flashes (green, every 5 seconds) and one confirmation tone is emitted
(sequence of tones rising in pitch).
u The device is shown in the internal list of handsets registered to the base.
On telephones that support the full range of functions (
with the name L410. If more than one Gigaset L410 is registered, a number is
appended to the name (L410-2, L410-3, etc.).
On other telephones: with the internal device name (e.g. INT 1, INT 2, etc.)
¤
Close the cover and apply pressure
until it locks into place.
Catch
5
£
page 16):