Advertisement
Wireless transmitter unit (TRX-1T)
1
Antenna
Adjust the antenna direction for best signal
transmission.
2
POWER indicator
Lights red when you connect the AC adaptor to the DC
IN jack on this unit and to an AC outlet. If the unit does
not receive a signal from the amplifier within 5 minutes
after connection to the AC outlet, it places itself in
standby mode and the power indicator goes out. The
unit turns on again when it receives a signal from the
amplifier.
Wireless receiver unit (TRX-1R)
The following figure depicts the unit with the cover removed.
1
2
1
AC power cable
Connect the plug to an AC outlet.
2
Surround speaker terminal
Connect the speaker cables to the surround sound
speakers.
3
CHANNEL SELECTOR switch
Set to the number selected on the channel selector of
the wireless transmitter unit (see page 5).
2
CONTROLS AND FUNCTIONS
1
2
3
Speaker terminal cable
Connect to the surround speaker jack on your amplifier.
4
CHANNEL SELECTOR switch
Set to the number selected on the channel selector of
the wireless receiver unit (see page 5).
5
DC IN jack
Connect to the included AC adaptor.
5
4
Antenna
Adjust the antenna direction for best signal reception.
5
POWER indicator
Lights red when you connect the AC power cable to an
AC outlet. Lights green when the unit receiving a signal
from wireless transmitter unit. When the signal from
the wireless transmitter unit is cut, the unit places itself
in standby mode, and the power indicator lights red.
5
4
3
4
3
Advertisement
