Checking Wiring And Connectors - Yamaha F2.5D Owner's Manual

Maintenance
1. Drain screw
3. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
Drain screw tightening torque:
18.0 Nm (13.3 ft-lb) (1.84 kgf-m)
NOTE:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into con-
tact with the surface of the drain hole. Then
tighten 1/4 to 1/2 turn more. Tighten the drain
screw to the correct torque with a torque
wrench as soon as possible.
4. Add the correct amount of oil through the
filler hole. Install the filler cap.
Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity (excluding oil filter):
0.4 L (0.42 US qt) (0.35 Imp.qt)
5. Start the engine and watch to make sure
the low oil pressure warning indicator (if
equipped) turns off. Make sure that there
are no oil leaks.
39
ECM00680
CAUTION:
If the low oil pressure warning indicator
does not turn off or if there are oil leaks,
stop the engine and find the cause. Con-
tinued operation with a problem could
cause severe engine damage. Consult
your Yamaha dealer if the problem cannot
be located and corrected.
6. Turn off the engine and wait 3 minutes.
Recheck the oil level using the oil level
check window to be sure the level falls
between the upper and lower marks. Fill
with oil if it is below the lower mark, or
drain to the specified level if it is above
the upper mark.
7. Dispose of used oil according to local
regulations.
NOTE:
For more information on the disposal of
G
used oil, consult your Yamaha dealer.
Change the oil more often when operating
G
the engine under adverse conditions such
as extended trolling.
EMU29111

Checking wiring and connectors

Check that each grounding wire is properly
G
secured.
Check that each connector is engaged se-
G
curely.