Tape Operation (Search System) - Panasonic PV-D4763SK Operating Instructions Manual

Tape Operation
Search System
For each recording, an invisible index mark is placed on the tape. A program index and
information are also included for timer recordings. These marks are used to access or
scan recordings.
Index Search
1
Press SEARCH*
INDEX SEARCH
to display SEARCH
ENTER INDEX NUMBER :1
in Stop or Play
USING 1- 9 KEYS
mode, and then
FORWARD SEARCH :FF
REVERSE SEARCH :REW
NEXT :SEARCH press NUMBER
EXIT :STOP
keys
to select recording
number.
• To calculate
Press FF/SLOW+
or REW/SLOW- on
the remote to start
search.
2 Play begins at
INDEX SEARCH
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
FORWARD SEARCH : FF
REVERSE SEARCH : REW
REW/SLOW- on the
remote while
screen left is
displayed (10 sec.).
• To cancel, press
To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1 2 3 4
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1 2 3 4
NOTE: indicates start points of each recording.
Note
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
30
D4763S-K(E) P26-35 (030325 MP).p65
Program End Search
Locates end point of recording for continuity.
1
Press SEARCH twice
to display SEARCH in Stop or Play
mode.
2
SEARCH START : FF
number, see below.
EXIT
Examples of Program End Search.
Fig. 1
the current tape position
Press SEARCH button
FF
Fig. 2
PLAY or STOP.
Fig. 3
Program 1
End Point
5 6 7
Upon locating end point,
➛ ➛ ➛ ➛ ➛ search continues 7 sec. past end point,
➛ ➛ ➛ ➛ ➛ tape rewinds to 10 sec. before end point,
➛ ➛ ➛ ➛ ➛ tape plays to end point and stops.
5 6 7
Note
• If Program End Search is started very close to
an index mark, that mark may be skipped over.
30
Press FF/SLOW+
PROGRAM END SEARCH
on the remote to
start PROGRAM
END SEARCH.
• To cancel, press
:SEARCH
PLAY or STOP.
Program 1
Program 2 or BLANK
End Point
Program 1 BLANK Program 2 BLANK
the current tape position
Press SEARCH button
End Point
FF
the current tape position
Press SEARCH button
BLANK
Program 2
If search exceeds
FF
a few seconds in
BLANK area.
2003/04/10, 10:01