Tape Operation (Search System); Index Search; Commercial Skip - Panasonic OmniVision PV-D4745 Operating Instructions Manual

Tape Operation
Search System
For each recording, an invisible index
mark is placed on the tape. A program
index and information are also included
for timer recordings. These marks are
used to access or scan recordings.

Index Search

1
2
To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1 2 3
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1 2 3
NOTE: indicates start points of each recording.
Note
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
30
Press SEARCH*
to display SEARCH
in Stop or Play
mode, and then
press NUMBER
keys to select
recording number.
• To calculate number,
see below.
Press FF/SLOW+ or
REW/SLOW- on the
remote to start
search.
Play begins at
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
REW/SLOW- on the
remote while
screen left is
displayed (10 sec.).
• To cancel, press
PLAY or STOP.
4 5 6 7
4 5 6 7
Zero Search
To quickly return to a specified tape location.
1
Press DISPLAY during play
to display Counter.
2
3
Continue to record, playback etc.
4
Press STOP.
5
• DECK will go into FF or REW mode and
stop at the last point the Counter was set
to 0:00:00.

Commercial Skip

DECK fast forwards (skips) over 1, 2, or 3 minutes
of recorded tape as desired.
1
Press CM/ZERO in Play mode.
• The skip time can be changed by pressing
CM/ZERO repeatedly as shown by the
figure below.
PLAY
1st Press
2nd Press
3rd Press
• No indication appears on-screen.
Press COUNTER
RESET on remote at
desired position to
reset to "0:00:00".
Press CM/ZERO
in Stop mode to start
Zero Search.
1 min Skip
2 min Skip
3 min Skip