Then, without shutting off the engine, follow
these steps:
1. Pull out the dipstick and wipe it with a clean rag or
paper towel.
2. Push it back in all the way, wait three seconds and
then pull it back out again.
The transaxle fluid
dipstick handle is
the red loop near
the rear of the engine
compartment. See
"Engine Compartment
Overview" in
the Index for
more information
on location.
3. Check both sides of the dipstick, and read the
lower level. The fluid level must be in the
-
cross
hatched area.
4. If the fluid level is in the acceptable range, push the
dipstick back in all the way.
6-21