TECHWOOD PLR-85 Owner's Manual page 9

14. SLEEP button
15. Preset buttons (0 -9)
These buttons are used to store and recall FM/AM sta-
tions in memory (See page 17).
16. MEMORY button
Use to store FM/AM stations in memory (See page 17).
17. MODE button
Use to select the Normal Tuning Scan or Preset Channel
scan modes.
See Radio Reception (See page 15 ~ 17).
18. TUNING/PRESET buttons
See Radio Reception (See page 15 ~ 17).
19. FM MODE button
When activated, this unit automatically switches into the
stereo mode when a stereo broadcast is received and
the stereo light illuminates.
Press this button again to listen in the mono mode.
The stereo indicator will not illuminate in the mono
mode.
20. BAND selector button
Each time you press the button, the bands will
change as follows.
FM AM
21. Level buttons
Use to adjust the volume of the center and surround
speakers.
22. Audio mode buttons
Use these buttons to select Stereo or Surround mode
desired.
23. TEST TONE button
This test tone helps you achieve proper speaker balance
in Dolby Pro Logic mode.
24. DELAY TIME button
Use to adjust the delay time. Set according to the room
and speaker set up to achieve the best soundfield. (See
page 21).
25. CENTER MODE button
Use this button to select center mode of Dolby surround.
– Normal, wide or Phantom.
9