Advertisement
Mount the dynamo
Only use the supplied dynamo with
the charger.
Attach the dynamo to the
mounting bracket
To attach the dynamo to the mounting
bracket, use the supplied bolt, nut,
and washer (12). Make sure the
bracket is firmly attached to the
dynamo.
Attach the bracket to the
front fork
To attach the mounting bracket to the
right side of the front fork on your
bicycle, use the supplied bolts, nuts,
and screw (13). Make sure the bracket
is firmly attached to the fork.
Mount the dynamo against
the tyre
To mount the dynamo against the
tyre, place the friction roller at the
correct angle, height, and distance to
the tyre (14) so that it properly
touches the side of the tyre when you
press the lever (15). Position the
dynamo correctly using the
adjustment bolt (16).
To detach the roller from the tyre, pull
the dynamo away from the tyre (17).
Attach the electric wire
To attach the electric wire to the
dynamo, firmly press and hold the
latch at the bottom of the dynamo
upwards (18), guide the bare end of
the wire through the hole (19), and
release the latch to lock the wire
in place.
ENGLISH
Advertisement
