Max Volume; Changing Volume; Start Volume - TAG MCLAREN AUDIO AV32R User Manual

volume adjustment and display
Volume (in the main or in zone 2) can be adjusted from 0 (very quiet) to 99 (very loud) if the
volume is configured to operate in Pre-Amp
you have configured the volume control for Cinema mode (factory setting)
In the Cinema mode the volume level of 0dB is the so-called 'Dolby reference level' – i.e. the
level at which a movie director intended a film to be listened
Pre-amp mode is indicated by ref being shown on the OSD at a volume level of 84.

changing volume

Turn the volume knob clockwise to increase the volume or anti-clockwise to decrease the volume
in 0.5dB steps. Alternatively, you may use the VOL + and VOL – keys on the remote to increase
or decrease the volume in 0.5 dB steps per key press. If you keep the VOL + / VOL – key
pressed, the volume change per second will increase the longer you keep the key pressed.
changing zones
You can assign two analog audio outputs to zone 2, for details see page 65.
If you have assigned zone 2, then you can switch between the main zone and zone 2 by
pressing shift, followed by VOL+ or VOL-. If zone 2 is selected, the front display's volume will
show ZN2 followed by the volume of zone 2.
main zone (4)
Turn the volume knob or press VOL+ and
VOL- to alter the signal level of all
connected loudspeakers of the main zone.

start volume

Normally the AV32R remembers the last volume setting for the main zone and zone 2 from
when it was turned off or put into standby, so that it will re-use exactly this volume when you
switch it on. start volume allows to set a volume level that the AV32R will use when powered
on regardless of any previous setting. You can set a different start volume (or none at all) for
the main zone and zone 2.
start volume is set within the Change Set-up -> Output/Speaker Options -> Main Zone or
Zone 2 menu.

max volume

This feature allows to set a maximum volume level that the AV32R will be allowed to be set to.
You can set a different max volume (or none at all) for the main zone and zone 2. Max volume
is set within the Change Set-up -> Output/Speaker Options -> Main Zone or Zone 2 menu.
1. the mode is change in Change Set-up -> Displays -> Front Panel Text Config. as described on page 46
2. They do not affect the signal level of the analog TAPE OUT or COAX OUTputs
3. This setting will only be accurate if you have calibrated the volume settings using a sound level meter.
4. The AV32R 'Dual Processor' must be set to main zone.
(1) mode or -90dB (very quiet) to +15dB (very loud) if
. The 'Dolby reference level' in
(3)
zone 2
If the AV32R is set to the main zone, press
shift followed by VOL+ or VOL- to switch to
zone 2 then adjust the volume, for zone 2
as normal.
|
.
(2)
25