Eco Menu; Setup Menu - Sharp Aquos LC-40LE530X Operation Manual

ECO menu

MENU [ ECO ]
ECO Setup
No signal off
Power management
4
No operation off
Ecology
I No signal off
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day
(Enable, Disable).
• Five minutes before the power shuts down, the remaining
time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme finishes, and the TV receives signal
input, this function may not operate.
I Power management (PC input mode only)
You can set the TV to automatically power off when no
image is displayed on PC.
Selected item
• No power management
Off
• Factory preset value.
• If no signal inputs for approximately
• 8 minutes, the power shuts down.
• Even if you start using the PC and the
Mode1
signal inputs again, the TV stays off.
• The TV turns on again by pressing
POWER (See page 9).
• If no signal inputs for approximately
• 8 seconds, the power shuts down.
• When you start using the PC and the
Mode2
signal inputs again, the TV turns on.
• The TV turns on again by pressing
POWER (See page 9).
I No operation off
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours
(30 min., 3 hr., Disable).
• Five minutes before the power shuts down, the remaining
time displays every minute.
NOTE
• "Disable" is the factory preset value.
I Ecology
When set to "Yes", the TV activates the following power
saving mode.
• "OPC" set to "On" (Page 13).
• "No signal off" set to "Enable" (Page 14).
• "Power management" set to "Mode1" (Page 14).
• "No operation off" set to "3 hr." (Page 14).
• "Quick start" set to "Off" (Page 16).
NOTE
• Ecology mode cannot be deactivated by selecting "No". Each
setting must be changed individually to deactivate Ecology
mode.
14
Option
[ Enable ]
[ 3hr. ]
Description

Setup menu

MENU [ Setup ]
Setup Option
Auto installation
Analogue programme setup
4
Digital programme setup
Child lock
Input skip
Input label
4
Position
HDMI auto view
4
WSS
4:3 mode
Quick start
Text language
Identification
Reset
I Child lock (ATV and DTV input mode only)
Allows you to use a password to protect certain settings
from being accidentally changed.
Setting a password
1
Repeat steps 1 to 2 in Menu operation.
2
Press a/b to select "Child lock", and then press
ENTER.
3
If you already set the password, enter it here.
4
Press a/b to select "Change password", and
then press ENTER.
5
Enter the 4-digit number as a password using 0
— 9.
Change password Enter your new password. Use 4 digits
Clear password
Parental rating
New password
6
Enter the same 4-digit number as in step 5 to
confirm.
NOTE
• To view a locked channel (Lock setting in Analogue
programme setup "Manual adjust" is set to "On"), you must
enter a password. When you select a locked channel, "Child
lock has been activated" is displayed.
• Press ENTER to display the password input window.
Clearing the password
Allow you to clear your password.
1
Repeat steps 1 to 3 in Setting a password.
2
Press a/b to select "Clear password", and then
press ENTER.
3
Press c/d to select "Yes", and then press
ENTER.
Digital setup
[ On ]
[ Panorama ]
[ Off ]
[ West Europe ]
– – – –
Reconfirm – – – –