MAINTENANCE
1
2
1. Exhaust vent
2. Inhalation vent
ACCESSORIES
CAUTION:
•
These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
•
Wheel guard (Wheel cover)
•
Inner flange
•
Depressed center wheels
•
Lock nut (For depressed center wheel)
•
Rubber pad
•
Abrasive discs
•
Lock nut (For abrasive disc)
8
Operation with diamond wheel (accessory)
WARNING:
•
Forcing and exerting excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of the motor and
dangerous kickback of the tool.
CAUTION:
•
After cutting operation, make sure that the diamond wheel stops
revolving completely. Then, place the tool. It is dangerous to place the
tool before turning off the tool. If there are dust or dirt around the tool, the
tool may suck in them.
Be sure that the wheel does not contact the workpiece. Turn the tool on and
hold the tool firmly. Wait until the wheel attains full speed. Now simply move
the tool forward over the workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed.
005809
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
The tool and its air vents have to be kept clean. Regularly clean the tool's air
vents or whenever the vents start to become obstructed.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspec-
tion and replacement, any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always using Makita
replacement parts.
•
Lock nut wrench
•
Wire cup brush
•
Wire bevel brush 85
•
Side grip
•
Dust collecting wheel guard
•
Diamond wheel