Introduction To The Wireless Lan Utility; Starting The Wireless Lan Utility - Alfa Network AWUS036H User Manual

Note:
This example is an open wireless network. If you are going to connect to an AP with
security protection, you will have to configure the encryption settings in this profile
to be corresponding to your AP. Please click on the "Network Authentication"
drop list to select an authentication method, and then select a "Data encryption"
type. Fill in each required blanks and click "OK".

Introduction to the Wireless LAN Utility

Note: This management instruction uses Windows 7 as the presumed operation
system. Some functions are not supported in Windows 98se or Windows ME.

Starting the Wireless LAN Utility

Double click the
up. You may click on the tabs above to configure this adapter. The checkboxes
below provide the following functions:
Show Tray Icon
Windows Zero Config
(on Windows XP)
Radio Off
Disable Adapter
Virtual Wifi Disallowed
(on Windows 7)
Alfa Network, Inc.
shortcut on your desktop. The Wireless LAN Utility will pop
Check this checkbox to show the utility icon on your
system tray, which is in the notification area at the
lower-right corner of the windows desktop. You may
also uncheck it to remove the utility icon from system
tray.
Uncheck this checkbox to use native Windows XP
wireless support (Wireless Zero Configuration Service)
instead of using this utility to configure your wireless
network.
Check this checkbox to prevent this adapter form
transmitting or
communicate.
Check this checkbox to disable this wireless adapter.
Check this checkbox to disable the Virtual Wifi Adapter
on Windows 7
16
receiving signals. Uncheck it to
Page 14