Operation; Pattern Control - Central Pneumatic 86 Set Up And Operating Instructions Manual

Setup
Refer to Figure 3 for the location of parts called out in this section.
Step 1. Move the LEVER (#29) counterclockwise until the YOKE (#30) is free from the CUP
LOCKS (#35).
Step 2. Lift and remove the Paint Gun from the CUP (#34).
Step 3. Prepare the paint or coating per the manufacturer's instructions for air spray guns.
Step 4. Fill the cup up to the ¾-full mark shown in Figure 4. DO NOT OVERFILL!
Step 5. Lower and replace the Paint
Gun onto the CUP.
Step 6. Align the YOKE with the CUP
LOCKS and move the LEVER
clockwise until tight. DO NOT
FORCE THE LEVER!
Step 7. Set the compressor's pressure
regulator to the lowest setting
recommended by the paint or
Step 8. Connect the TOUCH-UP
compressor's hose. If leaking is detected, disconnect the air hose and repair before
use.
The Touch-Up Gun is capable of spraying in different fan sizes and different shapes. Never
touch the trigger or point the gun at the face or body when adjusting the fan size or jet
shape.
Adjusting Fan Size
SKU 00086 For technical questions, please call 1-800-444-3353.

OPERATION

Figure 3 -- Operation Diagram
Figure 4--
Filling the Paint Gun

PATTERN CONTROL

CAUTION:
When the
CUP contains fluid,
always keep the Touch-
Up Gun upright. This
will keep paint from
contaminating portions of
the gun in which it is not
intended to go.
coating manufacturer.
GUN's coupler to the air
Page 5